Water On The Bathroom Floor After A Shower
A puddle on the bathroom floor after a shower points to one of four causes: the shower screen letting water past its seals, a shower floor that does not fall to the waste, a waste that drains too slowly, or a leak from behind the tiles. Where the water sits, and whether it appears during the shower or later, tells you which one you have.
Most of these are small repairs. The one to rule out quickly is the leak, because water that reaches the floor from inside a wall has already been somewhere it should not.
Where the water sits
Look at the floor straight after a shower, then again an hour later.
- Water at the screen door or along the hinge side is getting past the screen.
- Water across the step or the edge of the shower means the shower floor is holding water, or the waste cannot keep up.
- Water along the wall or the skirting outside the shower, with nobody splashing, is coming from behind the tiles.
The shower screen
A screen keeps water in with seals: a wiper strip along the bottom of the door, upright seals on the closing edge and the hinge side, and silicone where the fixed panels meet the tiles. Those seals perish, tear and slip, and a door that has dropped on its hinges no longer closes against them.
Water at the door edge or the hinge points here. The seals are replaced to suit the screen, the door is adjusted, and the silicone at the panel joins is cut out and redone. The screen side of this is covered in [shower screens and bathroom hardware](/blog/shower-screens-and-bathroom-hardware).
A shower head aimed at the door, or a hand shower left facing the wrong way, puts more water on the seals than they were made for. Sometimes the fix is turning the head.
The falls
A shower floor is laid with a fall, a gentle slope towards the waste, so water moves away from the edges. When the fall is too shallow, or the tiles have settled, water pools in a corner or creeps towards the step instead of the waste.
Pour a bucket of water across the shower floor and watch where it goes. Water that sits in one spot, or spreads outward, shows a fall problem. Fixing it means lifting the tiles and relaying the screed underneath to the right slope, which is a new shower floor with a new membrane under it.
A slow waste
If the shower floor fills while the water is on and empties slowly afterwards, the waste is partly blocked. Hair caught in the grate and the trap below is the usual cause, and cleaning both clears most of them.
A waste that stays slow after cleaning has a blockage further along the pipe. That one needs a plumber with a drain machine and a camera.
A leak behind the tiles
Water on the floor outside the shower when nobody has splashed, a skirting that swells, or grout outside the shower that stays dark all point to water escaping from behind the tiles. The source is a mixer or pipe joint inside the wall, or a failed membrane under the shower that lets water travel sideways beneath the bathroom floor.
That kind of leak does not stop at the bathroom. In an apartment, it shows up next as a stain on the ceiling below. Why the membrane fails, and how it is fixed properly, is explained in [the leaking shower, why it keeps coming back](/blog/the-leaking-shower-why-it-keeps-coming-back).
The bathroom floor itself
Some bathrooms have a floor waste outside the shower, with the floor sloping gently to it so splashes drain away. Many older bathrooms have no floor waste, or a floor that falls the wrong way, and every splash stays where it lands.
Water that sits on a bathroom floor finds the joints, and the junction between the floor and the walls is the weak point. Keeping that junction sealed matters more in a bathroom with no floor waste.
Silicone and grout
The joint between the shower floor and the walls, and between the hob and the bathroom floor, is sealed with silicone rather than grout, because it has to flex. When that silicone splits or peels away, water gets under the tiles at the very spot where it does the most harm. When and how it is replaced is set out in [silicone joints and when they need replacing](/blog/silicone-joints-and-when-they-need-replacing).
One team for the wet area
A glazier, a plumber, a waterproofer and a tiler each see one part of this, and each can fix their own part while the water keeps coming from another. One team checks the screen, the falls, the waste and the wall together and fixes the real cause, so the floor is dry after the next shower.
Our tiling and waterproofing work. Talk to us about a property.
Related Articles
Tell us about your building.
We will respond with a clear understanding of how we can help.
Get in Touch