Sagging Ceilings And What Holds Them Up
A ceiling should be flat. When it starts to dip between joists, bulge in the middle of a room or pull away from the cornice, something holding it up has failed.
Some sags are cosmetic and stay stable for years. Others are a warning that part of the ceiling could come down, and the difference lies in what the ceiling is made of and why it is moving.
What a ceiling is fixed to
Above every ceiling there is a frame, either the joists of the floor above or ceiling joists under the roof, sometimes with battens across them. The ceiling lining is fixed to that frame.
Plasterboard is screwed or nailed to the joists or battens, usually with adhesive as well. It is the lining in almost every building put up in the last few decades.
Fibrous plaster is the older lining in many houses and apartments built before the middle of the last century. It comes in large sheets of plaster reinforced with fibre, held up by plaster wads, which are lumps of plaster and fibre that grip the joists, along with nails or ties.
Lath and plaster is older again, with plaster pushed onto thin timber strips nailed to the joists.
Each of them fails in its own way.
Why plasterboard ceilings sag
Water. A leak from a roof, a bathroom or a pipe above soaks the board, and wet plasterboard loses its strength and droops. The board may dry out but it rarely goes back flat. The water side is covered in [water coming through a ceiling in an apartment](/blog/water-coming-through-a-ceiling-in-an-apartment).
Fixings too far apart, or adhesive that has let go, so the board slowly sags between the fixings.
Weight in the roof space, such as storage boxes, an old hot water tank or heavy insulation laid across the ceiling rather than on the framing.
Battens or joists that have moved, from a roof that has been altered or a frame that was undersized to begin with.
Why older ceilings sag
In fibrous plaster ceilings, the wads that hold the sheets up become brittle with age. Movement in the building, vibration, roof work or someone walking in the ceiling space can crack them. As they fail, the sheet relies on fewer and fewer fixings until it starts to drop.
The signs are a dip between joists, a crack running in a straight line across the ceiling, a cornice pulling away from the wall, or a section that moves when it is pressed gently from below.
Lath and plaster fails when the plaster loses its grip on the laths, and it tends to fall in pieces rather than sag as a sheet.
When it is urgent
A ceiling that is visibly bulging, has a fresh crack that is widening, has water pooling above it, or has dropped noticeably in days rather than years needs attention straight away. Keep people out from under it until it has been checked.
A plasterboard ceiling holding water is the most urgent case of all, because the weight can bring it down without warning. With the power to that area turned off, a small hole made to let the water drain into a bucket can prevent a much larger collapse.
The repair
Find and fix the cause first, whether that is a leak, a load in the roof space or a moved batten. Fixing the ceiling without fixing the cause brings the sag back.
Re-fix where the lining is sound. A plasterboard sheet that is dry and intact can be pushed back up and screwed off properly. A fibrous plaster ceiling in good condition can be secured again with new fixings from below or new wads and ties from above.
Replace where it is not. Water damaged board, or fibrous plaster that is cracked through, is cut out and replaced with plasterboard, then set and painted so the repair disappears. That side of the work is in [plaster repair after a water leak](/blog/plaster-repair-after-a-water-leak).
Keep the cornice where it matters. In a heritage interior, the ornamental cornice can often be kept or matched even when the flat ceiling is replaced.
Before anything is cut
In older buildings, ceiling linings and the dust above them can contain materials that need testing before they are disturbed. Some textured ceiling coatings and some fibre cement sheeting from the middle of the last century fall into that group, and that check comes first, as described in [asbestos in older buildings and what stops a job](/blog/asbestos-in-older-buildings-and-what-stops-a-job).
Why it is rarely one trade
A sagging ceiling under a bathroom is a plumbing or waterproofing repair, then a ceiling repair, then paint. A ceiling with downlights in it needs an electrician to take the lights down and refit them. A ceiling under a roof leak involves the roof.
One team that can trace the cause, fix it, rebuild the ceiling and paint it means the room is finished in one sequence and the sag does not come back.
Related Articles
Tell us about your building.
We will respond with a clear understanding of how we can help.
Get in Touch