Skip to main content
Building & Interiors

Rotten Timber Window Sills And Frames

John OwenFounder4 min read

Most rotten timber window sills are repaired rather than replaced. The soft timber is cut back to sound wood, a new piece is shaped and glued in, and the repair is primed and painted on every face. Replacement is the answer when the rot goes through most of the sill or has spread into the frame around it.

Either way, the repair lasts only if the cause is fixed at the same time. That cause is water sitting on timber that should have shed it.

Why sills rot first

The sill is the flat part at the bottom of the window. Rain lands on it, trickles down the glass onto it and sits there after every storm, and once the paint film cracks, the water soaks into the timber and stays.

End grain is the weak spot. The cut ends of a sill and the joints at the corners of the frame draw water in like a straw, and that is where rot tends to start.

Inside sills rot as well. In a bedroom or bathroom with heavy condensation, water trickles down the glass every morning and pools on the inside sill and the bottom rail of the sash. The causes of that are in [mould on a bedroom wall in a rental](/blog/mould-on-a-bedroom-wall-in-a-rental).

How to check a sill

Push a screwdriver into the timber at the ends of the sill, the corners of the frame and the bottom rail of each sash. Sound timber pushes back. Rotten timber is soft or spongy and lets the blade in with little effort.

Other signs are paint that bubbles or flakes in one spot, a dark patch that never dries, and a gap opening up along the joint between the sill and the frame.

Repair or replace

Small patches of rot, a few centimetres across, are dug out to sound timber, treated with a consolidant that hardens the remaining wood fibres, and filled with a two-part timber filler that is sanded to the shape of the sill.

Larger areas are cut out in a clean, square shape, and a new piece of matching timber is glued and fixed in, then planed to the original profile. Done well, the join is invisible once the paint is on.

A sill rotten right through, or one that has taken the frame with it, is replaced. That is a bigger job, because in a brick wall the sill is often built in under the frame, and taking it out without damaging the brickwork outside or the plaster inside takes care.

On a period building, repair before replacement keeps the window looking original, which is the approach in [heritage terraces, what changes about a trade job](/blog/heritage-terraces-what-changes-about-a-trade-job).

Old paint

Windows in a building from before 1970 can carry lead paint, and scraping or sanding them without the right controls spreads lead dust through the room and the garden. Old layers are tested before anyone starts, using the process in [lead paint in older homes](/blog/lead-paint-in-older-homes).

Paint is the protection

A timber window lasts as long as its paint film. Every new piece of timber is primed on all sides before it goes in, ends included, so no face is left bare to drink water.

The top of the sill needs a slight fall away from the window so water drains off. The underside needs a drip groove so water falls clear instead of tracking back to the wall. Two topcoats go over the primer, and the joint between sill and frame is sealed with a flexible filler that moves with the timber.

From then on, a look at the sills during each external repaint catches a crack before it lets water in, as set out in [external painting and when to repaint](/blog/external-painting-and-when-to-repaint).

The wall below the window

Water that has rotted a sill has sometimes run past it into the wall. Damp or bubbling plaster under the window inside, or a stain on the skirting below, means the wall is checked and dried before it is patched and painted.

Every trade in one window

A rotten sill is carpentry, painting and sometimes plastering, and it often comes with a sash that sticks or a lock that no longer lines up. One team works through the whole window in the right order, so the timber, the paint and the wall inside are finished without anyone waiting on the next trade.

Our carpentry work. Talk to us about a property.

JO

John Owen

Founder

Ample Trade, every trade a property needs held by one accountable team on one contact, across the Eastern Suburbs and the Sydney CBD.

CarpentryWindowsTimberPaintingOlder Buildings

Tell us about your building.

We will respond with a clear understanding of how we can help.

Get in Touch