Skip to main content
Painting & Flooring

New Carpet In A Rental Between Tenancies

John OwenFounder5 min read

New carpet in a rental goes down last, after the painting and every other trade, and it only lasts if the underlay, the edges and the doors are done properly. Worn carpet is the single biggest visual lift on a tired unit, so getting the details right is what makes the listing photos and the first inspection.

Carpet looks like the simplest finish in the property. It is not. The problems show up later, as ripples across the middle of the room, a gap opening at the doorway, and a smell that comes back after the first warm day because the old underlay was left in place.

What is under the old carpet

The old carpet and underlay come up together. The floor underneath tells you what the new one needs.

On a timber floor, loose or squeaking boards are screwed down now, because new carpet will not stop a board from moving. A board that is soft or stained near a bathroom or kitchen door points at a leak that has to be found before anything is laid over it.

On a concrete slab, high spots and old adhesive are scraped off, and a slab that feels damp is checked before the underlay goes down. Damp under new carpet turns into mould and smell, and the reasons are in [damp in basements and ground floor walls](/blog/damp-in-basements-and-ground-floor-walls).

Old staples, nails and gripper strips are pulled out. A staple left in the floor ends up as a lump in the new carpet.

New underlay, every time

Reusing old underlay under new carpet undoes the new carpet. The old underlay has flattened where people walk, it holds whatever was spilled or soaked into the old carpet, and pet odour lives in the underlay as much as in the carpet itself.

New underlay gives the carpet an even base, and it is the part that makes new carpet feel solid underfoot.

Edges, stretching and seams

Carpet is held at the walls by gripper strips, thin timber strips with angled pins, fixed around the edge of the room. The carpet is stretched across the room with a power stretcher and hooked onto them.

Carpet that is only kicked into place, without a proper stretch, ripples within months as people walk on it. That ripple is a trip point as well as a look problem.

Where a room is wider than the roll, the carpet is joined. The join is placed away from doorways and the main walking path, with the pile running the same direction on both sides, so the seam disappears.

Doorways and the edge of the hard floor

At the edge of tiles, timber or a hybrid floor, a trim holds the carpet edge down and covers the change in height. A trim that sits too high, or a carpet edge left loose, is where people catch a foot, which is the detail in [flooring transitions and trip hazards](/blog/flooring-transitions-and-trip-hazards).

New carpet and underlay can also sit higher than what came out. Internal doors that now drag on the pile are taken off and trimmed at the bottom, and the cut edge is sealed so the door does not swell.

The right carpet for a rental

For a rental the carpet has to handle wear and spills from one tenancy to the next. Solution-dyed nylon and polyester carpets hold their colour well and clean easily, and a cut pile in a mid-tone hides marks better than a pale shade.

Loop pile looks smart in a bedroom but can snag where there are pets. Whatever is chosen, keep an offcut from the same roll, because it is the only reliable match for a patch repair later.

Where carpet sits in the sequence

Carpet is laid after the walls and ceilings are painted, after the electrical and plumbing fit-off, and after every trade that makes dust or carries a ladder through the room. It is the most easily damaged surface on site, and once a drip of paint or a smear of grout is in the pile it does not come out cleanly.

That order is the core of [the finish a tenant sees first, paint and flooring between tenancies](/blog/the-finish-a-tenant-sees-first-paint-and-flooring-between-tenancies). Laid too early, the new carpet gets paint drips and boot marks before the first tenant has seen it.

In an apartment

In most apartment buildings, carpet replacing carpet is a straightforward job. Replacing carpet with a hard floor is a different decision because of noise to the unit below, which is covered in [hybrid and vinyl plank flooring in a rental](/blog/hybrid-and-vinyl-plank-flooring-in-a-rental). The building manager will still want the lift booked and protected, and the old carpet taken out of the building on an agreed route.

One team, laid last

On a turnover, carpet is the final step of a sequence that includes repairs, paint and fit-off. With one team holding that order, the carpet goes down once, onto a clean floor, after the dust is gone, and the doors close over it.

Our flooring work. Talk to us about a property.

JO

John Owen

Founder

Ample Trade, every trade a property needs held by one accountable team on one contact, across the Eastern Suburbs and the Sydney CBD.

FlooringCarpetRentalsRefreshRe-let

Tell us about your building.

We will respond with a clear understanding of how we can help.

Get in Touch