Skip to main content
Painting & Flooring

Paint Finishes For Each Room In A Rental

John OwenFounder4 min read

The finish that holds up in a rental is flat on the ceilings, washable low sheen on the walls, semi-gloss on the doors and trim, and a mould-resistant finish in the bathroom and laundry. Use the same products and colours throughout, and write them down, so a patch at the next changeover can be matched.

Colour gets most of the attention when a unit is repainted. In a rental, the sheen level and the quality of the prep do more to decide how the walls look after a few years of use.

What sheen changes

The shinier the paint, the easier it is to wipe clean and the more it shows every bump and patch underneath. Flat paint hides a wall's faults and marks easily. Gloss cleans easily and shows the lot.

A rental wall needs both things, a surface that has been patched more than once and that also gets wiped down. That trade-off drives every choice below. Names for the same level differ between paint makers, so check the sheen on the tin rather than going by what the range is called.

Ceilings

Flat, in a ceiling white. Light from the windows rakes across a ceiling, and flat paint hides old joins and patches better than any other finish in that light.

Bathroom and laundry ceilings are the exception. They take steam, so they get a moisture-resistant ceiling paint instead.

Living rooms and bedrooms

A washable low sheen acrylic in a neutral colour suits the main rooms. It wipes clean without polishing up, and it forgives the small repairs a wall collects over a few tenancies.

A touch-up rarely stays invisible, even with the same tin, because old paint has faded and fresh paint flashes over a filled patch. Patches are sealed and the wall is painted from corner to corner, as set out in [holes and dents in plasterboard walls](/blog/holes-and-dents-in-plasterboard-walls).

Hallways

Hallways take the furniture on moving day and the bags on every other day. A harder-wearing washable low sheen or satin suits them, because these are the walls that get scrubbed most.

Kitchens

Grease and steam make the kitchen a washing job, so the walls take a satin or semi-gloss made for scrubbing. Any wall that has seen years of cooking needs a proper wash with sugar soap first, or the new paint will not grip the grease.

Bathrooms and laundries

Use a paint made for wet rooms, with a mould-resistant film, on walls and ceilings that have been cleaned and sealed.

Paint does not fix a room that stays wet. If the exhaust fan is weak or discharges into the ceiling, the mould will come back through any paint, and the fix is in [bathroom condensation, mould and the exhaust fan](/blog/bathroom-condensation-mould-and-the-exhaust-fan).

Doors, frames and skirtings

Trim takes knocks and hands, so it gets a semi-gloss enamel. Water-based enamel dries quicker with less smell and holds its white for longer, while older oil-based enamel turns yellow as it ages, especially out of the sun.

The trap is painting one over the other. Water-based paint over old oil-based enamel peels away in sheets unless the surface is sanded and primed first. A rag with methylated spirits tells them apart, because acrylic softens and oil does not.

Older buildings

Paint on a building from before 1970 can contain lead, so old layers are not sanded until someone has checked them. The process is in [lead paint in older homes](/blog/lead-paint-in-older-homes).

Peeling or chalky paint gets scraped back to a sound surface and primed before any topcoat goes on. New paint over a failed layer simply fails along with it.

Coats and order

Bare patches get an undercoat, and the room gets two topcoats. One coat over a colour change almost always shows through in daylight.

Painting comes after the carpentry and every other trade that makes dust, and before the floor goes down, so the new floor never takes a drip. The reasoning is in [the finish a tenant sees first, paint and flooring between tenancies](/blog/the-finish-a-tenant-sees-first-paint-and-flooring-between-tenancies).

The paint record

This is the smallest job on the list and the one that gets missed. Write down the maker, the colour name, the sheen and the room, and keep it in the property file with a photo of the tin label.

Next changeover, the painter starts with the right product instead of guessing a white from a sample. On a portfolio, using one white and one trim colour across similar units saves the same guesswork again and again. The tenant never sees any of it, and the agent gets a repaint that looks the same as the last one.

Our painting work. Talk to us about a property.

JO

John Owen

Founder

Ample Trade, every trade a property needs held by one accountable team on one contact, across the Eastern Suburbs and the Sydney CBD.

PaintingRentalsRefreshRe-letMaintenance

Tell us about your building.

We will respond with a clear understanding of how we can help.

Get in Touch