Stairwell And Corridor Lighting In Strata Buildings
Stairwell and corridor lights in a strata building are on more than any light inside any unit, and the owners corporation pays for every hour of it. Upgrading them to LED fittings with sensors cuts the running cost and the number of lamp changes, as long as the emergency lighting and the sensor settings are handled properly.
Done badly, the same upgrade leaves a dark stairwell or removes the emergency lights without anyone noticing.
What the common area lighting covers
The lights in a strata building's shared spaces run on the common property supply. That usually means the lobby, corridors on every floor, the stairwells, the carpark, bin rooms and the external paths and entry.
Some run all the time. Others are on timers or photocells that switch them at dusk. In older buildings, many corridor and stair lights have simply been left on day and night for years.
Old fittings and their faults
The usual fittings in an older building are fluorescent battens and round ceiling lights with fluorescent or compact lamps. They fail in familiar ways: tubes flicker as the starter or ballast wears out, diffusers turn yellow and fill with insects, and lamps fail one at a time so that somebody is always on a ladder.
Lobbies often have halogen downlights that run hot and fail often. Replacing those follows the same steps as [downlights and LED retrofits in older ceilings](/blog/downlights-and-led-retrofits-in-older-ceilings).
LED fittings
Swapping the whole fitting for an LED one is usually better than fitting LED tubes into an old fluorescent body. The new fitting has no starter or ballast to fail, it is sealed against insects, and the light is even from end to end.
Matching the colour of the light across a building matters more than people expect. A corridor with warm white on one floor and cool white on the next looks unfinished, so the colour is chosen once and used everywhere.
Sensors
Sensors cut the running cost further.
Occupancy sensors in corridors and stairwells raise the light when someone walks in and lower it when the space is empty. In a stairwell the fitting should drop to a low level rather than switch off, so nobody steps into darkness on a landing.
Daylight sensors in lobbies and corridors with windows hold the lights down while there is enough daylight.
Photocells on external lights switch them at dusk and dawn, so the timer never needs adjusting through the seasons.
The settings matter as much as the hardware. A hold time that is too short leaves residents waving their arms in a dark corridor, and that complaint reaches the building manager quickly.
The emergency lights are separate
Many common area fittings are emergency lights with their own battery, designed to stay on when the power fails so people can find the exit. They are tested on a schedule, and they look much like the ordinary fittings around them.
Replacing one with a standard LED fitting removes the emergency function from that part of the escape route. Each emergency fitting is replaced with another emergency-rated fitting and tested afterwards. The system is explained in [emergency lighting and exit signs](/blog/emergency-lighting-and-exit-signs).
The ceiling after the fitting
An old batten or ceiling light leaves its outline on the ceiling. The new fitting rarely covers it, so the old fixing holes and the paint line around them need patching and painting to finish the job.
In a corridor that is used all day, that work is planned around residents, which is the approach in [painting common areas with minimal disruption](/blog/painting-common-areas-with-minimal-disruption).
The schedule
The work is booked through the building manager. A floor-by-floor schedule keeps half the building lit while the other half is worked on, so the stairs are never all dark at once.
One team for the whole job
An upgrade like this is electrical work, sensor setup, emergency lighting, ceiling repairs and paint. With one team doing all of it in order, the building ends up with lighting that works properly, emergency lights that are tested, and ceilings that look as if the new fittings were always there.
Related Articles
Tell us about your building.
We will respond with a clear understanding of how we can help.
Get in Touch