Skip to main content
Electrical

Smoke Alarm Chirping Or Going Off For No Reason

John OwenFounder4 min read

A short chirp every minute or so means the smoke alarm's battery is low, or the alarm itself has reached the end of its life. A full alarm going off in a room with no smoke means the alarm is reacting to steam, dust or an insect, or it has a fault.

Neither one is a reason to take the alarm down. The noise is the alarm doing its job, and the fix is quick once you know which problem you have.

The chirp

On most alarms, a single short chirp repeated about once a minute is the low battery warning. On an alarm powered only by batteries, a fresh battery of the type printed on the alarm stops it.

Hardwired alarms chirp too. They run on mains power and keep a backup battery for blackouts, and when that backup gets low they chirp like any other alarm, even with the power on.

Some alarms have a sealed lithium battery that cannot be changed. When one of those starts chirping, the whole alarm is due for replacement.

The date on the back

Every smoke alarm has a working life, and Fire and Rescue NSW advises replacing alarms every 10 years. The manufacture or expiry date is printed on the back or the side of the unit.

Many alarms give an end-of-life chirp when that time is up, and a new battery will not stop it. If the date has passed, or the alarm is so old that nobody can read the date, it gets replaced.

False alarms in a clear room

Something always sets it off, even when nothing in the room looks wrong. These are the usual causes:

  • Steam drifting from a bathroom to an alarm in the hallway
  • Smoke or heat from cooking, under a rangehood that is not pulling its weight
  • Dust from sanding, drilling or a renovation next door
  • Small insects inside the sensing chamber
  • Airflow from an air conditioner pushing dust into the alarm

Position sits behind most of these. An alarm right outside a bathroom door, or a few steps from the cooktop, keeps going off until it is moved or the moisture is dealt with. On the kitchen side, a rangehood that recirculates, or was never ducted outside, sends cooking smoke straight back into the room, as covered in [rangehood ducting and why it matters](/blog/rangehood-ducting-and-why-it-matters). The bathroom side is in [bathroom condensation, mould and the exhaust fan](/blog/bathroom-condensation-mould-and-the-exhaust-fan).

Fire and Rescue NSW recommends photoelectric smoke alarms for homes. An old alarm near the kitchen that keeps sounding while someone cooks is a good candidate for replacement with a photoelectric unit, fitted in a better spot.

Interconnected alarms

In many newer and renovated homes the alarms are linked, so one alarm sounding sets off every alarm in the home. That makes the source harder to find, because the noise comes from every ceiling at once.

Many interconnected alarms show which unit started it with a flashing light, so check each one before pressing anything. Alarms from different makers do not always work together, which is why a replacement in a linked set has to match the system already there.

What to do on the spot

Press the hush button, if the alarm has one, to quiet a false alarm. Then open a window and clear the steam or smoke. If the chirp is a battery, change it. If the alarm is past its date, or keeps going off in a clear room, book it in.

Do not take the battery out, pull the alarm off the ceiling or cover it with a bag. An alarm taken down to stop the noise is the one that stays silent on the night it is needed.

The repair

Hardwired alarms are licensed electrical work in NSW. The electrician isolates the circuit, fits a compatible alarm, checks the interconnection and tests every alarm in the home before leaving.

Some apartment buildings also have a detector wired back to the building's fire panel, inside the unit or in the corridor outside it. That detector belongs to the building's fire system, so a fault with it goes to the building manager and the fire services contractor.

In a rental, the alarm dates and the test result go in the property file, so the next replacement is planned before anything chirps. The wider picture for managed properties is in [smoke alarms in a rented property](/blog/smoke-alarm-compliance-in-a-rented-property).

On the same list

A chirping alarm is the job that gets put off because it seems too small to call anyone about. Sent with the dripping tap and the sticking door, it is handled the same week by the same team, and the tenant stops living with the noise.

Our electrical work. Talk to us about a property.

JO

John Owen

Founder

Ample Trade, every trade a property needs held by one accountable team on one contact, across the Eastern Suburbs and the Sydney CBD.

ElectricalSmoke AlarmsFaultsRentalsSafety

Tell us about your building.

We will respond with a clear understanding of how we can help.

Get in Touch