Skip to main content
Building & Interiors

Rental Kitchen Refresh Without A Full Renovation

John OwenFounder4 min read

A rental kitchen can be brought back to a standard that lists well without moving a single cabinet, as long as the cabinet boxes are sound and the layout works. A refresh replaces what the tenant touches and sees, the doors, handles, benchtop, splashback, tapware, lighting and paint, and leaves the plumbing and walls where they are.

The first job is finding out whether the cabinets underneath are worth keeping.

The cabinet check

The boxes behind the doors are usually particleboard. Under the sink, a slow leak swells the base and the sides until the board crumbles, and under the dishwasher the same thing happens from steam and drips. A box in that state cannot hold a new door or a new benchtop.

The other thing to check is fixing. Hinges that have been pulled out and screwed back in several times leave holes that will not hold another screw. Repairing or replacing a damaged box is part of the refresh, and the common faults are in [cabinet doors and drawers that no longer close](/blog/cabinet-doors-and-drawers-that-no-longer-close).

When most of the boxes have failed, the kitchen needs rebuilding rather than refreshing.

Doors, handles and hinges

New doors and drawer fronts on sound boxes change the kitchen more than any other single item. They are made to the sizes of the existing openings, hung on new soft-close hinges, and finished with handles that suit the doors.

Drawer runners are replaced at the same time, because a new drawer front on a worn runner still sags and sticks.

Benchtop and splashback

A chipped or swollen laminate benchtop dates a kitchen straight away. A new benchtop is measured on site, cut for the sink and cooktop, and joined so the joins sit away from the sink.

The splashback follows the benchtop, because the old tiles or panel rarely line up with the new top. The materials and the traps are in [kitchen benchtop and splashback replacement](/blog/kitchen-benchtop-and-splashback-replacement).

Sink and tapware

The sink and mixer come out with the old benchtop. The new ones go in with isolation valves on both supplies and new flexible hoses, because reusing old hoses under a new benchtop is how a kitchen floods. This is licensed plumbing work in NSW.

Rangehood and appliances

A rangehood that recirculates into the cupboard above, or one with a duct that ends in the ceiling space, sends grease and moisture into the building. The refresh is the time to fix the duct, as set out in [rangehood ducting and why it matters](/blog/rangehood-ducting-and-why-it-matters).

Old cooktops and ovens often come out at the same time, and a kitchen with no dishwasher can gain one if the cabinet layout allows it.

Lights and power points

Most older rental kitchens have one ceiling light and too few power points. LED strip lighting under the overhead cupboards lights the benchtop properly, and extra power points along the benchtop take the appliances off the powerboard. Both are licensed electrical work, run before the splashback goes on so the cables stay out of sight.

Paint and the floor

The ceiling and walls are painted once the dusty work is done, with a washable finish that handles cooking. If the floor is being replaced, it goes down after the paint and before the last trims.

Where a refresh stops

A refresh keeps the sink, the cooktop and the walls where they are. Moving the sink to a new wall, relocating the cooktop or taking out a wall turns the job into a renovation, with new drainage, gas or power lines and more trades involved.

In an apartment building, ask the building manager what the building needs to see for kitchen work before anything is ordered. A refresh that keeps everything in place is usually a short conversation, and a renovation that moves services is a longer one.

The order

The sequence is what keeps the kitchen out of use for the least time. The old doors, benchtop and sink come out. Plumbing and electrical are roughed in. The benchtop goes on, then the splashback, then the doors and drawers. Plumbing and electrical are fitted off, paint is touched up, and the kitchen is cleaned and tested.

One team on the kitchen

A kitchen refresh is carpentry, plumbing, electrical, tiling and painting, each waiting on the one before. With one team holding the order, the kitchen goes back into use finished, and the agent has one contact for the whole job.

Our carpentry work. Talk to us about a property.

JO

John Owen

Founder

Ample Trade, every trade a property needs held by one accountable team on one contact, across the Eastern Suburbs and the Sydney CBD.

KitchensRefreshRentalsCarpentryRe-let

Tell us about your building.

We will respond with a clear understanding of how we can help.

Get in Touch