Skip to main content
Every Trade, One Team

Refreshing Hotel Rooms While The Hotel Stays Open

John OwenFounder4 min read

A hotel can refresh its rooms while it stays open by working through them in small blocks, taking only those rooms off sale, holding noisy work to agreed hours and protecting the corridors and lifts that guests use. Each room goes back to housekeeping only when every trade has finished and every fitting in it has been tested.

The guests on either side are the measure of the work. If they never notice it, the refresh was planned properly.

What a room refresh covers

A refresh makes a room look and feel new without moving walls or plumbing. In most rooms it is a list like this:

  • Patching and repainting walls, ceilings, doors and trim
  • New carpet or hard flooring
  • Regrouting and resealing the shower, with worn silicone replaced
  • New tapware, shower heads and bathroom fittings
  • LED lighting, new switch plates and power points where guests want them, at the bed and the desk
  • Joinery repairs to wardrobes, desks and bedheads
  • Door hardware, closers and locks adjusted or replaced
  • Split systems serviced and condensate drains cleared

A room whose bathroom has failed underneath, with a leaking shower or a membrane that has given out, needs more than a refresh. Those rooms are scoped on their own and stay off sale for longer.

Rooms off sale

The hotel decides how many rooms it can lose at once, and the refresh is built around that number. Working by floor, or by a stack of rooms one above the other, keeps the noise and the trades in one part of the building.

The block of rooms, and the date each one returns to sale, is agreed with the front office before work starts. Once that date is set, it is held.

Noise and dust

Drilling, sanding and demolition are the noisy part, and they are held to an agreed window in the middle of the day, when the fewest guests are in their rooms. Painting, fitting off and testing are quiet and carry on outside that window. The rules that set noisy hours in a building are covered in [after hours work and noise restrictions](/blog/after-hours-work-and-noise-restrictions).

Dust is controlled at the source, with doors kept shut, floors covered and sanding done with extraction. Smoke detectors in the work area react to dust, so any isolation of detectors is arranged with the hotel and its fire services contractor before work starts and restored at the end of each day.

Corridors and lifts

Guests should never share a lift with a stack of plasterboard. Materials and rubbish travel in the service lift where there is one, at agreed times, and the path from the lift to the rooms is protected with floor covering and corner guards.

Trolleys and tools stay inside the rooms being worked on. At check-in and check-out times, the corridor is clear.

The order inside each room

The room is protected and stripped of anything being replaced. Electrical and plumbing changes go in first, then plaster patching, then joinery repairs, then paint. Grout and silicone in the bathroom are finished and left to cure. Flooring goes down last, so it takes no damage from the trades before it.

That is the same order a single fault follows when it is fixed between bookings, as set out in [a hotel room fault before check-in](/blog/a-hotel-room-fault-before-check-in). In a refresh it repeats in every room of the block.

Spare stock and records

Every room in a refresh gets the same carpet, paint, tiles and fittings, so a record of each is kept: the paint colour and sheen, the carpet range, the tile, the tapware model. Spare carpet, tiles and paint are stored on site.

The next scuff or damaged tile is then repaired to match, not patched in a near miss, and every refreshed room keeps looking the same long after the trades have gone.

Handback

Before a room goes back to housekeeping, every light, power point, tap, drain, door, lock and air conditioner in it is tested, and the room is checked against the list it started with. Anything outstanding is fixed before the room returns to sale, not after the first guest finds it.

One contact for the refresh

A refresh brings painting, flooring, plumbing, electrical, carpentry and air conditioning into the same rooms in a tight order. When one accountable team holds that programme, the hotel deals with one contact, one schedule and one report on each room, and the discretion described in [guest-ready, discreetly, trade work in a boutique hotel](/blog/guest-ready-discreetly-trade-work-in-a-boutique-hotel) carries through every floor.

How we work with hotels. Talk to us about a property.

JO

John Owen

Founder

Ample Trade, every trade a property needs held by one accountable team on one contact, across the Eastern Suburbs and the Sydney CBD.

HotelsRefreshPaintingFlooringScheduling

Tell us about your building.

We will respond with a clear understanding of how we can help.

Get in Touch