Why Does My Apartment Smell Like Sewage
A sewer smell inside an apartment is the drainage system telling you that a seal has failed. Every fixture connected to the sewer is meant to be sealed off from it, and when one of those seals stops working, the gas in the pipe finds its way into the room.
The list of causes is short. The harder part is that the smell rarely sits right on top of the fault, so the drain people suspect first is often the wrong one.
Rule out gas before anything else
Natural gas has an odour added so a leak can be noticed, and to some people it smells a lot like a drain. If there is any chance the smell is gas, treat it as gas: turn off the appliance and the meter if it is safe to reach, open the windows, leave the unit and call the gas distributor's emergency line. Do not switch lights or appliances on or off in the room while you do it.
Once gas is ruled out, the drainage causes below cover almost every case we attend.
The water seal and why it matters
Under every basin, shower, bath, laundry tub and floor waste there is a trap, a bend in the pipe that holds a small amount of water. That water is the seal. Sewer gas cannot pass through it, so the room stays clean even though the pipe beyond it goes straight to the sewer.
A toilet works the same way, with the water sitting in the pan doing the job.
So the first question on any sewer smell is which of those seals has lost its water, and why it lost it.
Dry traps in fixtures nobody uses
This is the most common cause by a long way. A floor waste in a bathroom that never gets wet, a second shower in a guest bathroom, or a laundry tub that has not been used since the tenant moved in will all lose their water over a few weeks, and then the drain is open to the sewer.
It is also the usual reason an empty unit smells bad at the start of a new tenancy, which is part of the routine in [vacant property checks and what fails while empty](/blog/vacant-property-checks-and-what-fails-while-empty).
The fix is to run water into every fixture and pour a bucket into every floor waste. If the smell clears and comes back within days in the same spot, a trap that keeps drying out may need a trap primer or a waterless seal fitted to the floor waste.
A toilet that has moved on its seal
The pan connects to the sewer through a rubber connector at the back or underneath. If the pan has been bumped, rocks slightly when someone sits on it, or was refitted after tiling without a new connector, that seal can open.
The signs are a smell that is strongest around the base of the toilet, sometimes a damp mark on the floor, and a pan that moves. Reseating the pan on a new connector usually solves it, and it sits with the other toilet faults in [toilets that run, rock or leak](/blog/toilets-that-run-rock-or-leak).
The basin overflow
The small hole near the top of a basin is the overflow. It leads down a channel inside the basin to the waste, and because clean water rarely flows through it, that channel stays damp and collects soap, hair and grime. Over time it produces a smell that seems to come from the drain but actually comes from the overflow itself.
A bottle brush and hot water down the overflow usually clears it.
Venting and why a trap gets sucked dry
A drainage system needs air as well as water. Vent pipes run up through the building to the roof, so that when a large volume of water goes down a stack, air can follow it without pulling the water out of the traps on the way.
When a vent is blocked, missing, or was never installed properly in a renovation, a toilet flushing upstairs or a bath emptying next door can pull the water out of a trap in your unit. The clue is a gurgling sound from a basin or floor waste when another fixture drains, followed by the smell.
In an apartment building the vent is part of the shared stack, so the fault often sits on common property rather than inside the lot. Who pays for that is the question in [common property or lot owner, who pays](/blog/common-property-or-lot-owner-who-pays).
A cracked or leaking pipe
A cracked waste pipe in a wall, under a floor or in the ceiling below can let gas escape without any water showing. Older buildings with original cast iron or earthenware drainage are the usual place for this, because the pipes corrode and the joints open with age.
A smell that is constant, gets worse in hot weather, and does not change when every trap is full points here. A camera inspection or a smoke test is the way to find it, because the smell alone will not tell you where the crack is.
The dishwasher and the washing machine
Appliances add their own drain connections. A dishwasher hose that drains into the sink waste without a high loop can siphon dirty water back into the machine, and a washing machine standpipe that is too short or partly blocked can hold standing water that turns sour.
Both are small jobs, and both get missed because the smell seems to come from the kitchen or the laundry in general rather than from the appliance.
Finding the source
The process is simple, and it works best done in order.
Fill every trap, including floor wastes and fixtures nobody uses, then wait a day.
Note where the smell is strongest and when it appears, for example after a shower upstairs, after rain, or after the unit has been shut up for a weekend.
Listen for gurgling when other fixtures in the unit or the building drain.
Check the toilet base and the basin overflow before calling anyone.
Call a plumber when the smell survives all of that, because the causes left are inside walls, floors or the shared stack.
A partial blockage further down the line can produce the same symptoms by holding water and waste where it should not sit, which is the reasoning in [blocked drains and what the blockage tells you](/blog/blocked-drains-and-what-the-blockage-tells-you).
When the repair crosses trades
A sewer smell traced to a toilet connector that failed when the floor was retiled is a plumbing repair with tiling attached. A cracked waste pipe in a wall means opening the wall, then sheeting, setting and painting it once the pipe is replaced.
One team that can do all of it means the smell is found, the pipe is fixed and the wall is closed up in one sequence, with no second trade booked to finish what the first one opened.
Related Articles
Tell us about your building.
We will respond with a clear understanding of how we can help.
Get in Touch