Skip to main content
Plumbing & Gas

Brown Or Rusty Water From The Tap

John OwenFounder4 min read

Brown or rusty water from a tap comes from one of three places: old pipes corroding inside the building, sediment stirred up in the water main in the street, or a hot water tank rusting from the inside. Which taps it comes from, and when it shows up, tells you which one you have.

In the meantime, run the cold tap until the water clears and hold off on the washing machine, because rusty water stains light clothes. Then find the source, since each of the three has a different fix and a different person to call.

Three questions

Hot, cold or both? Brown water from the hot tap alone points at the water heater. Brown water from hot and cold points at the pipes or the supply.

One tap or every tap? One tap points at the pipe feeding that tap. Every tap in the unit, or every unit in the building, points further back towards the street.

Does it clear? Water that comes out brown for a few seconds after sitting overnight and then clears has been sitting in a corroding pipe. Water that stays brown for several minutes is coming from somewhere bigger.

Old galvanised pipe

Many buildings from the middle of last century were plumbed in galvanised steel. The zinc coating wears through over the decades and the steel rusts from the inside, so water that sits in the pipe overnight picks up rust and comes out brown with the first run of the morning.

The same rust narrows the bore of the pipe until the flow drops, which is why brown water and weak pressure tend to turn up together. The pressure side of it is in [water pressure problems in apartments](/blog/water-pressure-problems-in-apartments).

Galvanised pipe at this stage does not recover. The fix is new pipe, either through one unit or up a whole riser, the way set out in [plumbing stack replacement in older buildings](/blog/plumbing-stack-replacement-in-older-buildings).

The water main

When every tap flows brown at once and the neighbours have it too, the cause is out in the street. Work on the main, a burst nearby or a hydrant being opened changes the flow in the main and stirs up sediment that has settled in it, and that sediment travels into every building on the line.

That one belongs to Sydney Water, not to the building, so report it to them. Run the cold tap for a few minutes at a time, and the water clears once the main settles down.

A smaller version happens inside a building after its own water has been shut off for a repair. When the supply comes back on, it pushes air and loose sediment through the pipes, and the taps splutter and run cloudy or brown for a short while.

The hot water tank

A storage heater holds its supply in a lined steel cylinder, protected by a sacrificial anode, a metal rod that corrodes so the cylinder does not. Once the anode is used up, the cylinder itself starts to rust, and the hot water comes out brown.

Brown hot water from an ageing tank is a warning, and it tends to arrive before the leak at the base that ends the tank's life. The repair or replace call is in [hot water, when to repair and when to replace](/blog/hot-water-when-to-repair-and-when-to-replace).

Black specks and white grit

Not everything in the water is rust. Black specks are often rubber from a perished tap washer or the lining of an old flexi hose, and that hose is worth replacing before it bursts. White grit is mostly scale from the hot water system.

Each one is traced the same way, by checking which taps show it and when.

When a tenant reports it

The first job is the three questions above. A photo of a glass of water from the hot tap and the cold tap, taken first thing and again after a minute of running, answers most of them before anyone attends.

From there it is a plumbing job inside the unit, a Sydney Water job in the street, or a building job if every unit has it. When old pipe in the walls has to come out, the plaster and paint that follow go on the same list, and the unit goes back to the tenant finished rather than patched.

Our plumbing work. Talk to us about a property.

JO

John Owen

Founder

Ample Trade, every trade a property needs held by one accountable team on one contact, across the Eastern Suburbs and the Sydney CBD.

PlumbingWater QualityOlder BuildingsHot WaterApartments

Tell us about your building.

We will respond with a clear understanding of how we can help.

Get in Touch