Water Leaking Under The Kitchen Sink
Water under a kitchen sink comes from one of three sources: the waste pipes that carry water away, the hoses that bring water in, or an appliance connected inside the same cupboard. Dry everything, test each part on its own and the drip shows where it is coming from.
Find it early. A slow leak in a sink cupboard soaks the cupboard floor for weeks before anyone opens the door, and particleboard that has swollen with water does not shrink back.
The paper towel test
Empty the cupboard, wipe every pipe and the cupboard floor dry, and lay a sheet of paper towel on the base. Then test one thing at a time.
Fill the sink and let it drain. Turn the tap on hot, then cold, with the plug out. Start the dishwasher on a short cycle if there is one. Whichever step wets the paper towel is the source.
The waste and the trap
The waste is the pipework under the plug hole: the outlet in the sink bowl, the trap below it and the pipe into the wall. Plastic waste fittings join with nuts and rubber washers, and over the years those washers harden and the nuts work loose.
A drip that only appears when the sink empties is almost always here. Sometimes a turn of the nut stops it. More often the washer is replaced, or the whole trap, which is a small part and a short repair.
A leak around the rim of the plug hole, where the outlet is clamped to the stainless steel bowl, is the seal under the outlet itself. The outlet comes out, the seal is renewed and the outlet goes back in.
The tap hoses
A mixer tap is fed by two braided hoses from isolation valves inside the cupboard. A drip from those connections shows up whether the sink is in use or not, because the hoses are under pressure all day and all night.
Braided hoses age, and the stainless steel braid hides the condition of the rubber hose inside it. Rust spots on the braid, a kink or a bulge mean a hose is near its end, and it is replaced before it bursts. The warning signs are in [why flexi hoses burst and when to replace them](/blog/why-flexi-hoses-burst-and-when-to-replace-them).
Water that pools around the base of the tap on the benchtop, then finds its way down through the tap hole, is a different fault. The tap's own seals have worn, and the tap itself is repaired or replaced. A replacement mixer should carry WaterMark certification, and connecting it is licensed plumbing work in NSW.
The dishwasher and the filter
A dishwasher has an inlet hose from a tap under the sink and a drain hose that joins the sink waste. Either one can weep at its connection, and the drain hose only leaks while the machine pumps out, which is why a dishwasher leak is easy to miss.
Water filters and boiling water units plumbed under the sink add more joints and more hoses, and each one is tested the same way. How a dishwasher should be connected in the first place is covered in [the dishwasher retrofit into a kitchen that never had one](/blog/the-dishwasher-retrofit-into-a-kitchen-that-never-had-one).
The cupboard floor
Many kitchen cabinets are particleboard with a melamine or laminate face. Water gets in at the cut edges, the board swells and softens, and the face lifts away. It does not go back.
A base that is only damp is dried and its edges sealed. A base that has swollen is cut out and replaced with moisture-resistant board, with every cut edge sealed before it goes in. If the cabinet sides or the kickboard below have swollen as well, the repair grows into the cabinet, the way set out in [cabinet doors and drawers that no longer close](/blog/cabinet-doors-and-drawers-that-no-longer-close).
Look at the floor under the cabinet too. In an apartment, water that gets beneath a kitchen can reach the ceiling of the unit below.
Three trades in one cupboard
A leak under a sink is plumbing first, carpentry second, and sometimes electrical as well, because the power point for the dishwasher often sits in the same wet cupboard. Handled in that order by one team, the leak is stopped, the cupboard is rebuilt and the power point is tested before anyone puts the cleaning products back.
Related Articles
Tell us about your building.
We will respond with a clear understanding of how we can help.
Get in Touch